The convenient and easy design meets the domestic demands for the construction equipment, which makes you easy to design and construct.
 
▲ Φ50PVC Pipe
Recommend to use the HuaguangΦ50PVC pipe.
▲ The 4 PVC electrical wire conduit
Host power cord
Please use the PVC electrical wire of 600V and two stranded wire of 5.5 mm².
Please use the 250V/16A ground-based dedicated outlet according to the set. For the indoor control wire, please use the PVC electrical wire of 1.25mm².
The location of the suction hole
◎For the sake of beauty, the location of the suction hole should be on the wall 30cm above the ground.
◎The collocated point of the suction hole should take 8cm as radius to consider about the scope.
◎Avoid placing on the outside wall which would make the scope smaller.
The location of the mainframe
◎The mainframe should be located on the balcony, garage or the mainframe room outside. The bottom of the mainframe should be 30cm above the ground, which makes it easier to change the dust collection paper bag inside the mainframe.
◎The mainframe should be 50cm far away from the ceiling and at lest 30cm from the corner, which makes it easier for the motor of the mainframe to let out the heat air.
The installation of the pipe and the conduit
◎Avoid the 90°camber， and the connector parts should be used in the camber (avoid the burned or 90°camber or T-shaped pipe), so as not to decrease the suction ability or to be choked.
◎The tie-in of the PVC pipe should be tight, and avoid the condition of leaking.
◎The places where the pipe will go should be accompanied with the conduit in parallel line. These two pipes should be fixed with thin iron wire.
◎There should be 15cm control wire left in the wiring closet and 45cm control wire in the mainframe, which is for the connection of the switch.
|
